I tried locating the studs from the inside.
Locating studs behind vinyl siding.
Then you can check for studs however you like drilling test holes etc.
Grab yourself a siding removal tool and pull up the top section of siding i m fairly certain you ll find a video on youtube on how to use it.
Measure 16 and mark additional stud locations.
Walk very slowly along the exterior siding while holding the stud finder.
You may detect a nail in the sheathing and it won t be a stud.
For vinyl siding use a vinyl siding removal tool to unsnap the seal between two pieces of siding allowing you to see the nail heads.
Insulation sheathing vapor barrier.
The best way to find a stud while working on on the outside whether brick siding or stone is to use an electronic stud finder.
I m having trouble finding the studs through the exterior of our home.
Older homes and some interior walls in newer homes have studs with 24 inch spacing and very old homes may have relatively random spacing.
Here s a super simple old school way to find a wall stud without having to buy an electronic stud finder.
Best way is from the inside.
In theory the siding should be nailed at the studs.
This is not always the case depending on the installer.
In most homes studs are spaced 16 inches apart measured at their centers.
Sadly you can t always rely on the nails holding any type of siding to indicate where the studs are but if it s vinyl over plywood the plywood nails should be a good guide.
Once you find the center of one stud you can measure horizontally to find more studs.
Using a window as a location guide use a stud finder on the inside to locate a stud or two and transfer that to the.
It s easy and works great.
The better way is to locate the edges of the osb sheathing.
The purpose is to anchor window boxes directly to studs on 2nd floor of the home.
Place the stud finder at the edge of the exterior siding.
Remove the section of siding at the elevation you plan on mounting the awning at.
For solid cladding such as stucco or brick your best bet is to locate the studs inside the house and then transfer the measurements to the exterior wall.
The walls are vinyl sided and i prefer not to have to lift it up.
The edges must be nailed into a stud.
Too many layers will give you a false reading.
