I haven t sleeved a cylinder but i have sleeved the main bearing journals on an onan twin cylinder engine i was told by every automotive ms within 100 miles that the crank could not be repaired so i experimented with stainless i ground the crank main journals under size and turned sleeves to fit i then turned down the new crank to size and polished the journals put it all back together and it.
Master cylinder stainless steel sleeve.
I think i should bore it out and press a brass sleeve in.
Most types of brake cylinders are suitable for re sleeving eg.
Special individual sleeves above 2 5 and up to 4 0 in diameter can be catered for on request.
We can sleeve the following.
Past parts video re sleeve of a brake master cylinder.
We have over 40 bore sizes in our standard tube range being pre drawn at the mill from high quality stainless steel with bore sizes ranging from 0 5 to 2 5 i d.
I know this can be done by professional shops.
Past parts video re sleeve of a brake master cylinder.
Step bore master cylinders.
Stainless steel sleeved and new brake and clutch cylinders.
Choose from our selection of stainless steel sleeves including fasteners sleeving and more.
This fit works fine on massive disc calipers but can break relatively thin walled master and wheel cylinders.
All of our sleeves are installed with a special sealer retainer and then press slip fit into the cylinder.
In stock and ready to ship.
We can resleeve the following.
Has anyone done this before.
The stainless steel sleeve resists wear and corrosion providing a long service life 3 8 24 iff fluid outlets accept 3 16 steel brake lines without the need for extra adapters pushrod is threaded 3 8 24 and will accept a yoke such as 91002973 this master cylinder is similar to those used on mid 70 s fords mustang fairlane ltd etc.
If a replacement is not available just post courier or deliver your old cylinders to us for full restoration.
For metallurgical reasons they must be put in with a quite tight interference fit.
I am restoring a willys jeep and the master cylinder is pitted.
The master cylinder has a 1 bore and is 4 long.
At edmonton brake clutch we have the right equipment to effectively bore sleeve and replace parts on all types of brake clutch cylinders.
You can phone us on 08 8261 0888 or you can email us at.
Much of the work we do is on cylinders.
Our resleeved cylinders are outfitted with long life stainless steel sleeves ranging from 11mm to 2 in bore size.
Stainless steel is able to be honed to provide a cross hatch pattern which aides in lubrication.
Step bore master cylinders.
